Husqvarna P 524X Manual De Usuario página 48

4. Lower the product.
Troubleshooting
If you cannot find a solution to your problems in this
manual, speak to your Husqvarna servicing dealer.
Problem
The starter motor does not turn the
engine over
The engine does not start when the
start motor turns the engine over
48
To lubricate the link rod
1. There are 2 grease nipples, one on each side of the
Troubleshooting
Cause
The PTO-button is activated. Refer to
19 or To start the engine (P 524X EFI) on page 20 .
The parking brake is not applied. Refer to
brake on page 23 .
The main fuse is blown. Refer to
The ignition key is defective.
The connection between the cable and the battery is bad.
The battery is too weak. Refer to
The starter motor is defective.
There is no fuel in the fuel tank. Refer to
There is air in the fuel system.
Preheating is defective or too short
The engine is defective.
To replace the fuel filter on page 29 .
The fuel filter clogged.
link rod. Lubricate with a grease gun until grease
comes out.
To start the engine (P 524X) on page
To apply and release the parking
To replace a fuse on page 31 .
To charge the battery on page 31 .
To fill fuel on page 18 .
1902 - 003 - 09.02.2023