Tig - Mma With Wire Feeder; Mig Mag With Wire Feeder; Software Update; Expansion Pcb - MMA Compacto Serie Manual De Uso

TIG - MMA WITH WIRE FEEDER

Save & Recall Key
19
Use the Save & Recall Key to save and recall the pa-
rameters set by the operator. The available memories
are 10.
To save the parameters proceed as follows:
• Press the Save & Recall Key - 19 -, the Left
Display - 16 - views the wording "OP" and
the Right Displays - 17 - views the number of
the selected operator point.
• Turn the Right Regulation knob - 12 - to
change the program number to save in.
• To save the program hold the SAVE Key - 19
-
To recall a saved program proceed as follows:
• Press the Save & Recall Key - 19 -, the Left
Display - 16 - views the wording "OP" and
the Right Displays - 17 - views the number of
the selected operator point.
• Turn the Right Regulation knob - 12 - to
change the required program number.
• To load the program press the RECALL Key
- 19 -
To exit SAVE & RECALL mode press Setup/Material
key - 18 -.

EXPANSION PCB

Ensure unit is powered off and unpluged
from the mains.
• Locate on the right side of the power unit the
expansion PCB compartment and remove the
closing panel.
• Take the expansion PCB and place it into the
white corresponding border on the PCB alre-
ady installed in the power unit.
• Plug and turn ON the machine, check that
the status led is working.
• After 60 seconds on the screen you will see
the new configuration vs. the old one
Figure 39 - Expansion PCB

SOFTWARE UPDATE

Status
LED

MIG MAG WITH WIRE FEEDER

Save & Recall Key
19
Use the Save & Recall Key to save and recall the pa-
rameters in the working list. The available memories
are 20.
To save the parameters proceed as follows:
• Press the Save & Recall Key - 19 -, the Left
Display - 16 - views the wording "LSt" and
the Right Displays - 17 - views the number of
the selected operator point.
• Turn the Right Regulation knob - 12 - to
change the program number to save in.
• To save the program hold the SAVE Key - 19
-
To recall a saved program proceed as follows:
• Press the Save & Recall Key - 19 -, the Left
Display - 16 - views the wording "LSt" and
the Right Displays - 17 - views the number of
the selected operator point.
• Turn the Right Regulation knob - 12 - to
change the required program number.
• To load the program press the RECALL Key
- 19 -
Note: with the wire feeder you can recall only the
operator points in the working list.
To exit SAVE & RECALL mode press Setup/Material
key - 18 -.

USB UPDATE

Ensure unit is powered off and unpluged
from the mains.
• Get an empty USB drive with maximum capa-
city of 8GB. Format it in FAT 32. SAVE into the
USB drive the updated program.
• Locate on the right side of the power unit the
expansion PCB compartment and remove the
closing panel.
• Insert the USB drive into the USB socket.
• Switch ON the machine holding MODE key
- 1 -. On the screen will appear USB CON-
NECTED.
• Release MODE key - 1 -.
• Once the software is updated a sound will
confirm you that the process is completed
• Remove the USB drive from the socket
• Close the expansion PCB compartment.
Figure 40 - "USB Connected" screen
EN-31