Descargar Imprimir esta página

Quattro EGO400 Guia De Instalacion página 12

Publicidad

Introduction
Thank you for choosing this caravan mover. This product has been produced according to high
standards and has undergone careful quality control procedures. Simply by using the remote control
you can move your caravan effortlessly into any position required within operating guidelines.
Before proceeding with installation and starting to use the mover, please read this manual
very carefully and be aware of all the safety instructions! The owner of the caravan will
always be responsible for correct use. Keep this manual inside your caravan for
future reference.
This installation manual covers two models of Caravan Mover: EM4446 - Ego Enduro and EGO400
- Quattro Titanium. Any differences between the models are detailed where appropriate. The mover
system consists of two 12V motor-powered rollers, a 12V electronic control box and a remote control.
To function, the motor-powered rollers must be engaged against the tyres of your caravan. The cross
actuation system enables you to simultaneously engage the rollers of both movers. Once this is done the
mover is ready for operation. The remote control will allow you to move your caravan in any direction.
Please be aware that certain installations in Germany are subject to further technical requirements
than in the rest of Europe. If after installation the caravan mover has easily accessible exposed
sharp edges not covered by the caravan bodywork, it is likely that an additional cover will need to be
installed. Please contact Purple Line for further assistance and see 'Optional fitting adapters' where
these optional covers are listed with installation explained.
Fitting Guidelines
The chassis clamps provided with this system are suitable for fitting onto most standard caravan
chassis that have an L-shape or U-shape profile (Fig.11). Please refer to Fig.13 for reference on
dimensions and clearances BEFORE you proceed any further with installation. If your chassis has
different dimensions to those shown in Fig.13 then various chassis clamp adapters are available to
suit the majority of UK and Continental caravans; please refer to the section of this manual entitled
'Optional Fitting Adapters'.
Specification
Model Number
Operational Voltage
Average Current Consumption *
Maximum Current Consumption **
Speed
Approx. Net Weight (inc. all fixings & accessories)
Safe Working Load (SWL) Twin Motor/Quad Motor
Minimum Width (caravan/trailer)
Maximum Width (caravan/trailer)
Power Source (caravan leisure battery)
* Average Current Consumption readings when using an approx. 1100kg single axle caravan on a
hard, level surface.
** Maximum Current Consumption readings when using an approx. 1100kg single axle caravan
ascending a 1:4 (25%) gradient.
EGO400
12V DC
25A (approx.)
120A
12cm/s (approx.)
35 kg
2250kg / 3500kg
1800mm
2500mm
12V
EN 11
EM4446
12V DC
25A (approx.)
120A
9cm/s (approx.)
40 kg
2250kg / 3500kg
1800mm
2500mm
12V

Publicidad

loading

Productos relacionados para Quattro EGO400

Este manual también es adecuado para:

Em4446