FUXTEC FX-RM4180 Manual De Instrucciones página 32

Original User Manual FUXTEC Petrol Lawnmower FX-RM4180
Place the device on a flat surface when filling the oil.
• Pull the cover with the dipstick out of the oil filler opening (see figure)
• After filling the oil, put the dipstick back into the hole and press it firmly.
• Pull out the dipstick again to check.
The oil level must be between the upper (MAX) and lower (MIN) limits (see figure).
Caution
DO NOT OVERFILL the oil tank. Otherwise, much smoke will come out of the exhaust when the
mower is started.
IMPORTANT INFORMATION:
Check the oil level before each use of the device. Top up with oil if necessary. Fill oil up to the MAX
level mark on the dipstick.
IMPORTANT INFORMATION:
Change the oil after the first 5 hours of operation and then after every 25 hours of operation.
ADD FUEL
After unscrewing the fuel filler cap, fill the fuel to the collar of the fuel tank, but do not overfill.
Always fill with fresh, clean, and approved unleaded petrol with an octane rating of at least 95.
Caution
If you spill oil or fuel on the device when refilling, wipe it away immediately. Do not store, supply, or
handle fuel near an open fire.
Caution
Fuels mixed with alcohol or fuels with ethanol or methane additives can bind moisture to
themselves, leading to segregation during storage and forming acids. The acid vapours can then
damage the fuel system of the device engine during storage. These fuels must not be used in the
device.
IMPORTANT NOTICE:
If you do not use the device for more than 30 days, empty the fuel tank, start the engine and let it
run until the fuel lines and carburettor are empty (the device will switch itself off). That prevents
future engine problems.
Fill the tank with fresh fuel before the subsequent use. For more information, see the chapter on
storage instructions.
32