Evolution H320-P Instrucciones Originales página 5

from the power tool before making any
adjustments, changing accessories, or
storing power tools. Such preventative
safety measures reduce the risk of starting the
power tool accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
Instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of moving parts and any other
condition that may affect the power tools
operation. If damaged, have the power
tool repaired before use. Many accidents are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended could
result in a hazardous situation.
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow
for safe handling and control of the tool in
unexpected situations.
5) General Power Tool Safety Warnings
[Service]
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
SAFETY INSTRUCTIONS FOR H320-P
a. Petrol or diesel powered engines must
never be used in unventilated closed spaces.
The exhaust fumes produced are highly
toxic and can cause 'Carbon Monoxide
Poisoning' which will cause drowsiness and
ultimately death. It is only permissible to run a
petrol engine indoors if the building can be very
well ventilated and the exhaust fumes can be
captured and ducted to the outside through an
exhaust extraction/scavenger system.
b. The engine should not be run at speeds
that exceed the maximum speed on the
rating plate. Operating an engine at excessive
speeds increases the likelihood of component
failure and consequent accidents.
c. Do not tamper with components that
regulate the engines speed. You may alter
the factory set running parameters.
d. Use only the type of fuel listed in this
Instruction Manual. Using fuel with an
octane rating less than that specified can
lead to excessive engine wear and premature
engine failure.
e. Keep the area around the engine clear,
clean and tidy. Never allow any combustible
material (timber, plastic, cardboard, canvas etc)
near a running engine.
f. Do not use in or near to potentially
explosive atmospheres. Dust laden
atmospheres as can be found in some
industrial buildings (Flour Mills, Timber Mills)
have an explosive potential.
g. Regularly check the fuel system for
leaks. Hoses and unions should be checked
for deterioration or chafing. Check the fuel
tank for damage or for a poorly fitting or worn
fuel cap. Any defects must be rectified before
the engine is used.
h. Always stop the engine and allow it to
cool down before refuelling. Try to avoid any
fuel spillage (often caused by 'overfilling' the
tank) and clean up any spilt fuel immediately.
The application of dry sand is an effective way
of neutralising fuel spills. Do not allow sand to
come into contact with any part of the engine.
i. When transporting the engine in a
vehicle ensure that the fuel tap is turned
off. To minimise the risk of fuel spillage the
engine should be secured by ropes etc to the
load area of the vehicle so that it cannot move
during transportation. The engine should be
secured in as level an attitude as possible.
j. For long term storage we recommend
that the fuel system of the engine is
drained. See Fig.20 for instructions. During
long term storage additives in modern fuels
can precipitate from the fuel and block jets and
valves in the fuel system.
www.evolutionpowertools.com 5