Aquona VYRTA Direct Flow Manual De Instrucciones página 35

7. PROBLEM IDENTIFICATION AND RESOLUTION
PROBLEM
1. Leak to the outside
of the unit
2. Zero production.
3. Low production.
4. Excessive roduction
5. Unpleasant taste
and smell.
6. White water
7. Continuous dripping
noise in drain.
8. The equipment does
not start.
9. The unit stops and
starts constantly.
10. Constant water to
drain.
CLOSED
Read the INTERFACE section of the Data Sheet. In case of anomaly contact the SAT and proceed as directed:
Close the entry valve. Open the faucet to depressurize the system and unplug.
POSSIBLE CAUSE
Several possible causes.
1. There is no water supply.
2. There is no power supply.
3. Leaking sensor activated.
1. Partially closed inlet valve.
2. Filters / membrane's service life
ended.
Several possible causes.
Several possible causes.
Air in the system. Microbubbles of
air that disappear after a few se-
conds.
Several possible causes.
1. There is no water supply.
2. There is no power supply.
3. Leaking sensor activated.
Several possible causes.
1. Inlet solenoid valve defective.
2. Check valve defective
OPEN
SOLUTION
Call technical support.
1. Wait for the supply to return.
2. Check the power supply of the
unit. In case of not solving the problem, call
the technical service.
3. Leaking sensor activated. If a leak is not
detected dry the base of the equipment
along with the leak sensor. If the problem
persists call the technical service.
1. Open it completely.
2. Call technical support.
Call technical support.
Call technical support.
It's not a problem. The appearance will di-
sappear as the air inside the equipment is
expelled.
Call technical support.
1. Check the status of the general inlet and
the equipment inlet.
2. Check the general power supply. If the
problem is not fixed, call technical support.
3. If the leak is not detected, dry the bottom
of the equipment along with the leak sensor.
If problem persists, call technical support.
Call technical support.
1. Review and replace.
2. Review and replace.
35