Publicidad
Idiomas disponibles
Idiomas disponibles
RECOMMENDED MAINTENANCE CF
Prefilter: at least every 12 months. *
RO osmosis membrane: Every 2 years approx (for soft
treated waters (hardness <15 ºHF)). CB Postfilter: At
least every 12 months.
Sanitization: In the start-up. At least every 12 months
depending on use. Each time components in contact
with water in the equipment are accessed or no water
has been consumed for more than a month.
* Depending on the intended use and characteristics of
the water to be treated.
Maintenance must be carried out by trained personnel,
who must handle the equipment properly, as well as
use original spare parts to maintain the characteristics,
warranty, certifications and performance of the equi-
pment and thus preserve the quality of the water dis-
pensed.
ATTENTION: The use of non-original spare parts,
installation outside the limits of operation and
commissioning, improper maintenance or use, may
lead to the loss of the guarantee, as well as the invali-
dation of any kind of quality certifications.
An excess in some compound (total chlorine, turbidity,
hardness, etc ...) can cause a reduction in the life of filters
and certain components. These maintenances are indica-
tive.
The distributor will foresee the duration of the consuma-
bles according to the characteristics of the water to be
treated and the expected consumption in each case.
ATTENTION: All consumables are supplied with
individual packaging specially designed forgua-
rantee hygienic storage and transport conditions.
Exercise extreme precautions after removing the con-
sumables from their packaging and while handling the
various connectors and components.
ATTENTION: Before disassembling the equipment,
provide all the material that you will need to carry
out maintenance operations (read the Table 5 Installa-
tion) and the space required for it. Work in a well-lit
place, in adequate hygienic conditions and with enou-
gh space to carry out operations comfortably.
ATTENTION: To change the filter cartridges, the
equipment must be depressurized beforehand.
To do this, close the inlet valve water to the equipment
and open the dispensing tap for a few seconds until
water hardly comes out and then cuts off the power
supply to the equipment. Once the equipment has been
depressurized, you can change the cartridges.
• Perform filter change properly. Ensure the tightness of
the joints and the original hydraulic configuration of the
system as recommended by the manufacturer.
• Sanitize the equipment following the instructions des-
cribed in the Sanitation Procedure.
• For more information, consult the technical data
sheet of the equipment. If you have any other ques-
tions, consult your dealer.
Technical Manual
ATTENTION: Use gloves or appropriate personal
protection measures, if you use chemicals during
sanitization.
Publicidad
