Quick SMART CHC Manual De Instalacion Y Uso página 18

SMART CHC
3.0 - INSTRUMENT OPERATION
3.1 - User interface
SMART CHC è collegabile direttamente a un qualsiasi comando
per salpa ancora ON/OFF prodotto da Quick, come per esempio
joystick, pulsanti e pulsantiere up/down.
The monitor is activated when the connected command is
switched on.
Main screen showed after switching on the SMART CHC.
WARNING: before using the gauge, it must be configured using
the application (See Page 19-20).
3.2 - Information shown on the display
The SMART CHC gauge displays the following operating states in related to the activities carried out on the windlass
0
.
0
meter
STOP
STOP WINDLASS
WHITE STEADY BARGRAPH
Warnings: opposing commands, sensor not detected or warping motor activation, low voltage.
OPPOSITE
COMMANDS
WARNING
OPPOSING COMMANDS
18
30
.
0
meter
CHAIN UP
ANCHOR UP (M/FT)
RED MOVING BARGRAPH
NO SENSOR
OR WARPING
WARNING SENSOR NOT DETECTED OR
WARPING MOTOR ACTIVATION
INSTALLATION AND USE MANUAL - REV 001A
0
.
0
meter
STOP
LOW VOLTAGE
30
.
0
meter
CHAIN DOWN
ANCHOR DOWN (M/FT)
GREEN MOVING BARGRAPH
LOW VOLTAGE
LOW VOLTAGE WARNING
BARGRAPH
MEASUREMENT OF THE
CHAIN DOWN
UNIT OF MEASURE
WINDLASS STATUS
ALLARM SIGNAL
30
.
0
meter
FREE FALL
ANCHOR FREE FALL (M/FT)
GREEN MOVING BARGRAPH
0
.
0
meter
STOP
OPPOSITE COM
THE WARNINGS REMAIN VISIBLE
ON THE DISPLAY UNTIL
THE PROBLEM IS SOLVED.
EN