Quick SMART CHC Manual De Instalacion Y Uso página 20

SMART CHC
4.0 - CONFIGURATION
4.2 - Device configuration
The CHC Quick Smart App allows quick configuration
of the SMART CHC gauge via smartphone.
Switch on the SMART CHC, start the App, and position the smartphone
in the wireless area indicated by the arrow.
NOTE: the position of the NFC antenna on the smartphone
F
depends on the model.
Please refer to the manual provided by the smartphone
manufacturer.
After receiving confirmation of the NFC reading from the smartphone,
select one of the following:
SET TO ZERO : reset the measurement of the lowered chain.
SET UP : Configuration of the SMART CHC parameters.
SET
TO ZERO
SET UP
SET
TO ZERO
SET UP
20
TO READ
THE CURRENT CONFIGURATION
JUST POSITION YOUR SMARTPHONE
ON THE SMART CHC
SETTING TO ZERO
Press the SET TO ZERO button and position the smartphone
on the NFC area of the SMART CHC
Wait for NFC confirmation and check
ENABLE
that the device was set to zero.
SCAN
SET UP
BACKLIGHT
SETTING UP THE DEVICE
meter feet
300
Press the SETUP button.
mm
GYPSY CIRCUMFERENCE
The screen will display that it is possible to set
2
the SMART CHC use parameters.
NUMBER OF MAGNETS
5.0
sec
ON OFF
AUTO FREE FALL
SEND
INSTALLATION AND USE MANUAL - REV 001A
EN