MO-EL 793 Uso Y Mantenimiento página 5

EN
1. CAUTION REGARDING THE SECURITY
Instructions should be carefully read before installation and retained by the user. The book-
let must be keeped and delivered to the new user in case of cession of the machine. The
Manufacturer reserves the right to vary the features of the product without prior notice. The
technical data are merely indicative.
1. This appliance is intended solely for the use it has been designed for, namely room heat-
ing. The Manufacturer is not responsible for any damage that could happen for improper
use.
2. After unpacking make sure that the appliance is complete and shows no signs of visible
damage or tampering.
3. Keep packing materials, which are potential dangers, away from children.
4. The appliance is not suited for persons (as well as children) physically, mentally, sensory
disabled, or with no experience, unless they have been supervised or directed by some-
one responsible of their safety.
5. Do not let the children play with the appliance.
6. Before inserting the plug make sure that the voltage is the same as indicated on the
device.
7 . Do not use in presence of gas, inflammable or explosive liquids or substances.
8. Some fundamental rules which apply to all electrical devices must be observed when
using the heater:
Do not touch the heather with wet hands.
•
Do not handle with bare feet.
•
Do not pull the electric cord or the device itself to unplug it from the socket; pull
•
the plug directly.
Do not let children play with the electrical appliance.
•
9. Avoid the use of an extension cord with this product, because the extension cord may
overheat and cause a risk of fire.
10. Do not apply any modification to the product that could compromise the safety.
11. Keep connections dry.
12. If the appliance is not used for a long period, disconnect it from the power supply.
13. Always disconnect the appliance before doing any maintenance operation.
2. CAUTION REGARDING THE INSTALLATION OF THE APPLIANCE
Installation should always be carried out by a qualified electrician or a competent person in
accordance with the standards HD 384 CENELEC for Europe, or international IEC 60346-7-
708 1988, and the standard AS/NZS 3000 (Australian wiring rules). The energy supply must
be done through a properly grounded socket. The appliance must be connected to the power
supply by a H05RN-F cable, gotten properly into dimension in respect to its own length and
the kind of the connection (see the Table 1).
A omni-polar overvoltage category III circuit breaker with contact opening dis-
tance of at least 3 mm must be fitted upstream from the supply line.
Be careful to connect the heater to a supply line protected by 16 A fuses not
quick-acting type (25 A for mod. 792).
All manuals and user guides at all-guides.com
USE AND MAINTENANCE
5