Publicidad
Idiomas disponibles
Idiomas disponibles
9. Repeat steps 1 to 8 until no more resi-
dues are coming out.
10.Pull out the mains plug, allow the device
to cool down, and pour off any remain-
ing water.
9. Storage
DANGER!
Store the steam iron out of the reach of
children.
1. Set the temperature controller 17 to
MIN.
2. Place the steam iron on the stand 7.
3. Allow the device to cool down.
4. Set the steam flow rate controller 3 to
.
5. Set the switch 11 to the position
appropriate.
6. Remove the iron from the stand 7 and
pour off any remaining water through the
filling opening of the water tank (under
the lid 2).
7. Place the iron on the stand 7 and set the
switch 11 to the position
8. FIGURE D: wind the power cable 9
around the cable spool 10 and fix it in
place using the cable clamp 22.
9. Store the iron and the stand 7 in an up-
right position.
10. Disposal
This product is subject to the
provisions of European Direc-
tive 2012/19/EC. The sym-
bol showing a wheelie bin
crossed through indicates
that the product requires sep-
arate refuse collection in the European Un-
ion. This applies to the product and all
accessories marked with this symbol. Prod-
ucts identified with this symbol may not be
discarded with normal household waste, but
must be taken to a collection point for recy-
cling electric and electronic appliances. Re-
cycling helps to reduce the consumption of
raw materials and protect the environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.
11. Trouble-shooting
If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
if
Do not attempt to repair the device your-
self under any circumstances.
Fault
.
No
function
Little or
no steam
Steam
burst is
not work-
ing.
Possible causes/Action
• Connect the device to the
mains power supply.
• Use the temperature control-
ler 17 to turn up the temper-
ature.
• Fill the water tank 15 to at
least one quarter full.
• Switch on the steam flow
rate controller 3
(
).
• Run the self-cleaning cycle.
• Fill the water tank 15 to at
least one quarter full.
• Set the right temperature.
• Leave a pause of a few sec-
onds between steam bursts.
GB
25
Publicidad
