MSA Gallet F1XF Manual Del Operador página 13
Ocultar thumbs
Ver también para Gallet F1XF:
- Manual de instrucciones (173 páginas) ,
- Manual de funcionamiento (171 páginas) ,
- Manual del usuario (125 páginas)
Publicidad
Idiomas disponibles
Idiomas disponibles
5 Maintenance and Cleaning
4.6
Mask Adapter (Kitfix)
Attach a mask using the "Kitfix" connector kits A.
5
Maintenance and Cleaning
The length of the useable life of this helmet will be affected by the type(s) of material used in its construction and
the environments in which the helmet is used and stored. Recommendations on this topic should be sought from
the manufacturer.
WARNING!
Do not apply paint, stickers, cleaning products with a hydrocarbon base or solvents to the helmet or visors to
prevent damaging the materials of your helmet.
Failure to follow this warning can result in serious personal injury or death.
Do not drop the helmet.
Prevent the helmet from impacts which could damage the shields (cracks/scratches).
The parts in contact with skin have to be inspected regularly for cracks or wear that could cause
discomfort. Changing those parts regularly will maintain user comfort level.
To maximize helmet lifetime:
•
Store the helmet in a proper storage bag and/or in a closed cabinet to avoid extended exposure to cold,
humidity, exhaust fumes, etc.
•
Clean the helmet (shell and internal components) after use before storing.
Checks After Each Use
After each use, check every part of the helmet and especially all the fixing points:
•
Correct anchor points used
•
No evident wear
•
No fractures or cracks
Check that the helmet fit is always correct.
Maintenance by a Trained Maintenance Specialist
13
2.
Insert the lamp into the lamp bracket from the rear open side (A).
3.
Rotate, then press forward to secure the attachment (B).
4.
Tilt the lamp up and down into the required position.
5.
To remove the lamp, slightly press it towards the helmet while sliding it to
the rear open side (A) of the lamp bracket.
To adjust mask tightness on helmet:
1.
Use a pair of pliers to remove the pin.
2.
Adjust the Kitfix to position (1) (2) or (3) (according to desired
mask tightness).
3.
Use the pin to lock the Kitfix in place (push it in completely).
4.
Test mask seal after attaching the mask if necessary.
GB
Publicidad
