IP Cleaning IPC CLEANTIME 40 Manual De Instrucciones página 17

The packed machine body must be lifted only with a fork lift truck. Handle with care to
avoid bumps or overturnings.
5.2 Checking the machine on delivery
On delivery check with attention that the package and the machine are not damaged. In
the event that the machine has suffered any damages, report so to the carrier; before
accepting the goods, reserve by written the right to present a claim for the refund of the
damages.
5.3 Unpacking
On unpacking the machine, the operator must be provided with the necessary
accessories (e.g. gloves, protective goggles etc.) to limit possible hazards of
Unpack the machine in the following way:
• cut and remove the plastic straps with scissors or nippers;
• remove the cardbox;
• remove the envelopes inside the battery compartment (within the solution tank) and
check its contents:
envelope 1:
envelope 2:
• depending on the model, remove the metal brackets or cut the plastic straps, which fix
the machine chassis to the pallet;
• let the machine slide down the pallet on an inclined plane, by pushing it into reverse;
• unwrap the brushes (fig. 3, ref. 1) and the squeegee (fig. 3, ref. 2) from their packing;
• clean the outside of the machine observing the safety rules;
• after unpacking the machine, you can install the batteries (models with battery) or
perform the electric connections (models with cable): see respective paragraphs.
If necessary, preserve the wrapping material as it could be used again to protect the
machine in the event of a move or if the machine should be sent to a service centre for
repair.
Otherwise, the material must be disposed of in compliance with the laws in force.
5.4 Electric connections and grounding (models with cable)
On the identification plate (fig. 1) the electric characteristics of the machine are written:
make sure that the frequency and line tension are the same of those of the environment
where you are going to work.
As far as voltage is concerned, the models showing a voltage of 230 V on the plate can
be used for voltages ranging from 220 to 240 V. The same is true for the models showing
a voltage value of 115 V, which can be used for voltages ranging from 110 to 120 V. The
frequency indicated on the plate must always correspond to that of the mains.
Check that the electric plant is provided with a suitable ground line and that the
plugs (and any reducers being used) guarantee the continuity of the ground lead
WARNING
accidents.
- test sheet;
- warranty coupon;
- user's and maintenance manual;
- list of spare parts;
- cards with serial numbers to order spare parts;
- 1 battery bridge with clips (for battery models only);
- 1 pair of tweezers for fuses (for battery models only);
- 1 connector for the battery-charger (for battery models only);
WARNING
wires.
ENGLISH
9