IP Cleaning IPC CLEANTIME 40 Manual De Instrucciones página 20

•
put the machine on the pallet, by anchoring it with plastic straps or the proper metal
brackets;
•
lift the pallet by means of a fork lift truck and load it on the vehicle;
•
anchor the machine to the vehicle with ropes connected to the pallet and to the
chassis of the machine.
6.1 Control devices - Description
With reference to fig. 6 the machine has the following controls and leds:
• Power supply led (fig. 6, ref. 1 – in models with cable only): it is green and indicates
that the power supply cable of the machine is connected to mains.
• Battery charge check led (fig.6, ref. 1 – in models with battery only): consisting of 3
yellow leds, it indicates the battery charge level. It can be:
a) 3 leds on: batteries charged from 100% to 50%;
b) 2 leds on: batteries charged from 50% to 18%;
c) 1 led on: batteries almost flat;
d) 1 led blinking: batteries completely flat; after a few seconds the brushes are locked
and the brush switch light also comes on.
• Brush switch with led (fig. 6, ref. 3): enables ("1") or disables ("0") the function
"Brush".
• Suction switch with led (fig. 6, ref. 2): switches on ("1") or off ("0") the suction motor,
which allows to dry the floor just washed. The led is on when the suction unit is fed.
• Cock control lever (fig. 6, ref. 6): allows to adjust continuously the flow of solution
sent to the brushes. Pull up to increase the liquid outflow.
• Drive control lever (fig. 6, ref. 7): the drive control lever permits forward movement of
the machine and rotation of the brushes.
• Squeegee lifting lever (fig. 6, ref. 8): it allows to raise (when lifted) or lower (when
pushed down) the squeegee.
• Direction adjustment knob (fig. 6, ref. 10): turn to correct any deviation of the
machine and keep it moving in a straight line.
• Head lower/lift pedal (fig. 6, ref. 9): located on the left-hand side of the machine,
when pressed it lowers/raises the brush head.
• Solution tank level indicator (fig. 6, ref. 5): the led comes on to indicate insufficient
water in the solution tank.
• Recovery tank level indicator (fig. 6, ref. 4): when the recovery tank is full the led
comes on and after a few seconds the suction motor locks out.
6.2 Installing and adjusting the squeegee
The floor wiper, also called squeegee (fig. 2, ref. 6), is the first responsible for drying.
To install the squeegee on the machine proceed as follows:
1) check that the squeegee supporting plate (fig. 7, ref. 2) is raised, otherwise lift it by
acting on the proper lever (fig. 7, ref. 5);
2) firmly push down the sleeve of the suction tube (fig. 7, ref. 4) into the squeegee;
3) slacken the two knobs (fig. 7, ref. 3) placed in the centre of the squeegee;
4) insert the two threaded dowels in the slots of the support (fig. 7, ref. 2);
5) fix the squeegee by tightening the knobs (fig. 7, ref. 3).
The blades of the squeegee are used to scrub from the floor the film of water and
detergent thus allowing a perfect drying. As long as time goes by the continuous scraping
rounds off and splits the sharp edge in contact with the floor, thus reducing the drying
efficacy and therefore requiring the replacement of the blades. Therefore, often check
their state of wear and tear.
ENGLISH
12
6.
PRACTICAL GUIDE FOR THE USER