IP Cleaning IPC CLEANTIME 40 Manual De Instrucciones página 21

To obtain a perfect drying action it is necessary to adjust the squeegee in such a way that
when it is in operation, the rear blade lip is bent about 45 degrees with respect to the floor
at all points. The angle of the blades during work can be adjusted by adjusting the height
of the two wheels positioned behind the squeegee (fig. 7, ref. 1).
6.3 Movement of the machine when not operating
To move the machine, perform the following operations:
1) raise the squeegee;
2) push the head movement pedal down and then to the right (fig. 6, ref. 9) to raise the
head;
3) move as follows:
- versions with mechanical drive: push or pull;
- versions with electrical drive: operate the drive lever (fig. 6, ref.7).
4) once you have reached your destination, lower the head by pressing the release pedal
down to the left (fig. 6, ref. 9) and then release it.
Do not leave the machine unattended or parked with the head lifted or with the key
6.4 Fitting and changing the brushes / drive discs
Do not work without the brushes or drive disc perfectly fitted.
Before removing the brushes, stop the machine, press "0" on the brush switch (fig. 6, ref.
3) and on the suction switch (fig. 6, ref. 2), wait for the brushes to come to a standstill and
raise the head. Disconnect the power supply (cable or battery).
Fitting the brush: rest the brush on the floor in front of the machine and centre it with the
casing. Lower the head and operate the brush/drive control lever (fig. 6, ref. 7) for a few
moments: in this way, the brush automatically engages on the flange hub. If this operation
is not successful, press the handgrip again and repeat centring and operation of the
brush/drive control lever.
Use of abrasive discs: fit the abrasive disc on the drive disc and perform the operations
described for fitting the brush on the cleaner.
Removing the brush (or drive disc). Follow the instructions below:
raise the machine head by pushing the head lift pedal down and then to the right (fig. 6,
ref. 9) and repeatedly operate the brush/drive lever in short spurts. After a few times, the
brush (or drive disc) will be released and fall to the ground.
6.5 Detergents - Use
Always dilute detergents according to the supplier's instructions. Do not use
sodium hypochlorite (bleaching solution) or other oxidizers, especially if in high
concentrations, and do not use solvents or hydrocarbons. The temperatures for
water and detergent must not exceed the maximum temperatures indicated in the
technical data and must be free from sand and/or other impurities.
The machine has been designed to be used with non-foaming and biodegradable
detergents specific for sweeping scrubbers.
Contact the Manufacturer to have a complete and updated list of the available detergents
and chemical products; you will receive all papers together with the Manual "Complete
cleaning system".
Use only products suitable for floors and for removing dirt.
Follow the safety rules concerning the use of detergents indicated in the paragraph
"Safety regulations".
WARNING
inserted in the emergency button.
CAUTION
WARNING
ENGLISH
13