Revell Control BUGGY 4x4-GBL Manual Del Usuario página 8

1. GETTING STARTED:
IMPORTANT: Before driving the buggy for the fi rst time, check the signal between the remote conrol and
the receiver in the vehicle as described in the section about binding. Before operating the vehicle, always
ensure that the controller for setting the maximum speed on the remote control is set to MIN and the
controller for setting the left/right steering is in the middle position.
Place the vehicle on the fl oor with its rear facing you. Connect the cables from the battery and motor in
the buggy (Fig. 1). Also ensure before starting that the trim controls for speed and steering
(TH. TRIM and ST. TRIM) are at their middle positions.
Be sure to follow this order when switching on the buggy: Set the ON/OFF switch on the side of the
remote control to "ON" (Fig. 2). The two power LEDs on the remote control light up red and green when
the battery is fully charged (Fig. 3). Then set the ON/OFF switch on the buggy to "ON" (Fig. 4). Two acoustic
signals indicate: the buggy is ready for operation.
Please note: When the buggy and remote control are switched off, the ON/OFF switch on the side of the
buggy must be set to "OFF" fi rst (see Fig. 4). Only then should you set the ON/OFF switch on the remote
control to "OFF" (Fig. 2). Otherwise you can accidentally give a signal that causes the buggy to start by
itself, which can lead to signifi cant damage.
2. TRIMMING SPEED AND CONTROLLER:
Correct trimming is crucial for ensuring that the buggy drives smoothly. It is easy to do, but does require a little patience and a light touch. Please follow these instructions carefully:
If the buggy moves forwards or
backwards without a backwards without anyone touching
the speed co the speed control...
If the buggy moves forwards or backwards without anyone
touching the speed control, turn the speed trim control in the
opposite direction until the buggy stops by itself.
3. BUGGY CONTROL:
Forward movement
To start the buggy and move forward, carefully pull the speed
control. To go faster, carefully pull the speed control further.
To take left corners, turn the steering control to the left,
assuming the back of the buggy is facing the driver.
8
RC_Anleitung_Buggy_GHz_24503.indd 8 RC_Anleitung_Buggy_GHz_24503.indd 8
Driving the buggy
Braking and reversing
To brake, carefully push the speed control forward until the buggy
stops or slows down. To reverse, push the speed control further.
To take right corners, turn the steering control to the right,
assuming the back of the buggy is facing the driver.
Fig. 1
Fig. 3
If the wheels of the buggy turn
to the left or right without anyone
turning the steering...
If the buggy's wheels turn to the left or right without anyone turning the
steering, turn the steering trim control in the opposite direction until the
wheels are straight and the buggy moves in a straight line. It is best to trim
the steering while the buggy is travelling slowly.
4. CONTROL FOR SETTING THE
MAXIMUM SPEED AND
STEERING ANGLE
Fig. 1
The controls for setting the steering angle (ST.D/R) and the maximum
speed (TH.D/R) determine the maximum steering angle of the wheels
and the maximum speed of the buggy. Before starting, beginners
should set the control for the maximum speed to MIN and the control
for the steering angle should be set to the middle (Fig. 1). These
controls should only be adjusted when the buggy and remote control
have been mastered. Do not change the settings while the buggy is
in motion.
Fig. 2
Fig. 4
Tip: The reverse switches for the
speed control (TH) and steering
control (ST) can be used to reverse
the function of the respective
controls. The settings should only
be changed while the buggy and
remote control are switched off.
31.03.10 12:12 31.03.10 12:12