Nolan N304 P Seguridad E Instrucciones página 28

N30-4 P
2 DISASSEMBLY
2.1 Remove the cap rear frame from the cavity between the polystyrene inner shell and
the outer shell by slightly pulling on the eyelet at the cap lower left end (Fig.32C).
2.2 Lift the cap from the outer shell upper surface (Fig.33).
2.3 Remove the left side tab of the cap front frame from its corresponding housing in
the helmet front air intake. Then follow the operation with central tabs and with
right side tab (Fig.34).
If you wish to use the helmet with visor or peak, check that the cap frontal area
is properly assembled, by lifting and lowering the visor or the peak, that should
be able to move freely. If not, repeat the operations 2.3, 1.3, and 1.4.
WARNING
- Carefully wash by hand and use only mild soap and water at 30° C max.
- Rinse using cold water and dry at room temperature, away from direct sunlight.
- Never machine-wash the cap.
- Never use tools or equipment to carry out the operations described above.
28
INSTRUCTIONS FOR USE