Publicidad
Idiomas disponibles
Idiomas disponibles
back of the machine. Pull out the hose (B) from the chas-
sis and connect to container.
E10.
Using cleaning agents: Set the desired concentration of
(A) or (B) cleaning agent at the dosing knob.
Spray the object. Allow the cleaning agent to work, de-
pending on the degree of soiling. Then rinse off with the
high pressure spray jet. Never allow cleaning agent to dry
out on the object as the surface may be damaged.
After using the unit or before leaving it unattended
F1.
Switch off the cleaner. Turn the switch to position "OFF".
F2.
Disconnect supply lines.
F3.
Close water tap.
F4.
Squeeze the spray gun to release pressure.
F5.
Lock the safety catch on the spray gun.
NB! In standby mode, when using hot water, the machine
may intentionally enter bypass mode, and automatically
return to standby mode.
Storing the cleaner:
It is recommended to empty the tank of water in case the ma-
chine will not be used for a long time.
G1.
Rotate the front blue cover to detach it from the cleaner.
G2.
Remove isolation part (A) from top of the tank.
G3.
Turn and move the tube vertically along the guiding slot of
the locking plate (B). The end of the tube is released from
the bottom of the tank and water is thrown away.
G4.
The tank can also be emptied by opening the discharge
valve (C) located in back of the tank and connecting a
hose to it.
NB! The cleaner must be stored in a dry and heated
location above 32°F to protect against freezing.
Maintenance & trouble shooting
H1.
Water inlet – Large filter: Tilt glas outward, unscrew glass
and clean with water.
H2.
Pump oil: Check the pump oil quality: Check colour of
pump oil. If the oil has a dark grey or white shade, contact
Nilfisk service!
Top up cold pump with fresh oil to MAX if necessary.
Original instruction
F
G
H
13
Publicidad
