Publicidad
Idiomas disponibles
Idiomas disponibles
MSxe/MSx 636 (US) - Buch Seite 8 Donnerstag, 9. Oktober 2003 11:46 11
EN
Replacing tools (3).
!
Risk of injury
- caused by the power tool unintention-
ally switching ON.
Before replacing the tools, ensure that
you disconnect the plug from the
power supply.
- caused by sharp tools, e. g. scraper,
knife or blade.
Locking screw with small washer (5b):
For sanding pad, sanding finger, polishing
pad, tungsten-carbide file.
Locking screw with large washer (5c):
For saw blades, spatula, segmental and
cutting blades.
Unscrew the locking screw with the
Allen key (5a).
Replace tool and secure with the
appropriate locking screw. Ensure that
the tool is correctly seated on the tool-
mount flange and that the bearing sur-
face is clean.
Attaching/replacing the sanding
sheet (4).
Align the sanding sheet and press on by
hand. In case of using stick-on sanding
sheet remove cover foil before.
Press the sanding sheet briefly and
forcefully onto a level surface and
switch ON the power tool.
This ensures good adhesion and pre-
vents premature wear.
When the point is worn, remove the
sanding sheet, rotate by 120° and re-
attach or replace.
Attaching the dust extractor
(Accessory) (6).
8
MSxe 636 II / MSx 636 II
MACHINING METHOD.
Sanding.
Materials: Wood, paint, metal, stone.
Typical applications:
Sanding small areas, particularly in cor-
ners, along edges and in areas which are
difficult to access.
Sanding down and stripping window
frames, furniture, railings, etc.
Sanding rust off vehicles.
Also random orbit, belt or orbital
sander for sanding doors, gates, boats,
wooden floors, wooden stairs, etc.
Operating tips:
When sanding, move the power tool
continuously and apply light pressure.
Work with the sanding pad flat on the
material; do not work with just the
point.
Do not apply excessive pressure; this
will not increase the cutting perfor-
mance, but will simply wear out the
sanding pad quicker.
Select a high oscillating frequency
(if power tool is adjustable).
Sawing with saw blade (3b).
Materials:
a)
With standard saw blade – wood,
old putty, plaster, plastic.
b)
With HSS saw blade – as above but
with significantly longer service life;
also for fiber glass, sheet metal
(e. g. body sheet metal) up to
1 mm.
Typical applications:
Cutting wood for detail work.
Publicidad
