Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installation
Installation area
Warning!
！
Stability is important to prevent the
product from wandering!
Make sure that the product should not
stand on the power cord.
Before installing the machine, the location
characterized as follows shall be selected:
1.Rigid, dry, and level surface
2.Avoid direct sunlight
3.Sufficient ventilation
4.Room temperature is above 0°C
5.Keep far away from the heat resources such as coal or gas.
Unpacking the washing machine
Warning!
！
Packaging material (e.g. Films, Styrofoam) can
be dangerous for children.
There is a risk of suffocation! Keep all packaging
well away from children.
1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base packing. Make sure the
small triangle foam is removed with the bottom one together. If not, lay
the unit down with side surface, then remove the small foam from the
unit bottom manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
Remove transport bolts
Warning!
！
You must remove the transport bolts from the backside before using the product.
You'll need the transport bolts again if you move the product, so make sure
you keep them in a safe place.
Please take the following steps to remove the bolts:
1.Loosen 4 bolts with spanner and then remove them.
2.Stop the holes with transport hole plugs.
3.Keep the transport bolts properly for future use.
w
w
W> 20mm
V.2
Publicidad
