Fein SuperCut Instrucciones De Manejo página 10

3 41 00 981 06 1 - Buch Seite 10 Montag, 10. November 2003 8:20 08
EN
!
Damage to property/material
Mains voltage must correspond with the
voltage specifications on the power tool.
Personal protective equipment.
When using this power tool wear the fol-
lowing protective items:
Protective gloves, safety goggles and ear
protection.
Handling.
Switching ON/OFF (1).
First check that the cable and plug are
not damaged.
Switching the power tool ON:
Slide switch (1) forwards (I).
Switching the power tool OFF:
Press the switch (1) down at the
back (0).
Set the oscillating frequency (2).
The speed regulator (2) can be used to set
the optimum oscillating frequency accord-
ing to the accessories used and the respec-
tive application.
Mount the hand and machine
guard (3).
The hand and machine guard (accessory,
order number 3 18 10 242 01 6) is man-
datory for work undertaken on the out-
side of buildings. It is fastened in the two
bores on the driving head using Phillips
screws.
10
Mounting the tool (4).
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
Always wear protective gloves.
Remove the screw (4).
The internal thread M 8 and the receptacle
of the drive shaft must be clean.
Tighten the screw (4) firmly with the
pin-type face spanner.
Torque 12 – 13 Nm.
For adopting a comfortable working posi-
tion the tool can be fastened on the drive
shaft at 30° intervals.
The sanding disc fixation on the drive shaft
is infinitely variable. The adapter is
required when working with the sanding
disc (accessory, order number
3 01 09 128 01 8).
Sharpen the cutter at the lowest fre-
quency before each application with a
sharpening stone. This also applies for
new cutters.
The cutters marked with a symbol (5)
may only be operated according to the
marking. They are not suitable for other
power tools.
SuperCut