SodaStream E-TERRA Manual De Instrucciones página 19

CREATE THE BUBBLES
COMPATIBLE WITH
THE FOLLOWING ONLY:
Check for compatibility
on the Bottle pack.
1. Fill the plastic carbonating bottle with cold water up to the fill line.
WARNING! Do not carbonate anything other than water. Other
liquids can contaminate and clog internal parts, potentially
resulting in excessive pressure, bottle failure during carbonation
and serious injury. Never carbonate after flavoring has been
added.
2. To insert the plastic carbonating bottle, make sure that the bottle
rest is angled forward. Please make sure you do not pull the
carbonating tube. WARNING! Never use a Sparkling Water Maker
with a broken carbonating tube. This can cause excessive
pressure, bottle failure and serious injury. Insert the bottle neck
into the Snap-Lock system. Push the plastic carbonating bottle up
and back. The Snap-Lock will hold the plastic carbonating bottle.
3. To carbonate, press as follows to get the desired carbonation level:
• For 1L Plastic Carbonating Bottle: left button (one bubble) for light
fizz; Middle button (two bubbles) for medium fizz; Right button
(three bubbles) for strong fizz.
• For 0.5L Plastic Carbonating Bottle: Left button (one bubble) for
medium fizz; Middle button (two bubbles) for strong fizz.
4. The button will flash slowly indicating that it is carbonating and will
flash quickly when carbonation is complete. Pressing any button
during carbonation will stop the carbonation process. When the
desired level of carbonation is achieved, gently pull the Plastic
Carbonating Bottle towards you until it reaches its fully forward
position. This will release the pressure in the Plastic Carbonating
Bottle and allow the Plastic Carbonating Bottle to be released
from the Snap-Lock.
WARNING! Do not remove plastic carbonating bottle until after
hearing the sound of excess CO
plastic carbonating bottle out of the Snap-Lock system. Always
allow the Sparkling Water Maker to release the plastic carbonating
bottle. If the plastic carbonating bottle does not immediately
release from the Snap-Lock system wait a few moments. If it still
does not release, then push the plastic carbonating bottle back
into the vertical position and gently pull it towards you again.
Attempting to remove the plastic carbonating bottle while it is
still pressurized can cause uncontrolled ejection of the plastic
carbonating bottle and may result in serious injury.
1L
SodaStream®
being released. Never force the
2
0.5L 1L
plastic carbonating bottles
Note: when inserted correctly, there is
a small gap between the bottom of the
Plastic Carbonating Bottle and the
base. Do not carbonate if the Plastic
Carbonating Bottle is resting on the
base, or water will splash out.
3
Note: You may see small pieces of
ice appear in the water during
carbonation of very cold water. Any
ice created will simply melt.
4
1
2
19