HOOKII Neomow S Manual De Usuario página 18

Charging and Testing
After the successful connection of the charging station and boundary wire , test
the robotic mower's function. (If the mower is too power-low to start, place the
mower in the charging station. Make sure the charging is successful. )
Check the LED regularly to ensure fixing the boundary wire has not affected the
connection and signal shows P1 on the charging satation.
Then place the mower in the working area, a few meters beside the docking
station. Set the main power switch to "ON".
Press the buttons
the mower should automatically return to the charging station by locating and
following the boundary wire in anti-clockwise direction. If the mower fails to
dock correctly move the docking station to a more suitable location.
Note:
Successful docking and charging indicates that you have found a suitable position
for the docking station. You should now drive the fixing pegs into ground fully.
Signal Selection
There are two signal which can be selected, P1 and P2. Make sure the mower
and charging station are using the same signal.
If your neighbour is using the same mower, ensure that both products are using
different signals. Please refer to the section of "Signal setting" in order to select
signal P1 or P2 for your installation.
home and OK
15
Original instructions
in order,a few seconds later,
EN EN