Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL OPERATION
The transmitter has ON and OFF manual functions that are activated by pressing either button on the face of
the transmitter. When a button on the transmitter is pressed the word ON or OF will appear on the LCD screen
to show while the signal is being sent. Upon initial use, there may be a delay of three seconds before the re-
mote receiver will respond to the transmitter. This is part of the system's design.
POWER SETTING – CON 1001 TH
The electronics in the remote control system have the capability of "powering" two different types of DC-pow-
ered components. If any operational problems are noted, contact Customer Service. The RECEIVER comes
from the factory programmed to provide pulse DC voltage (5.5 VDC to 6.3 VDC) to a latching solenoid.
REMOTE RECEIVER
THE REMOTE RECEIVER SHOULD BE POSITIONED WHERE AMBIENT
TEMPERATURES DO NOT EXCEED 130° F.
The remote receiver (right) operates on (4) 1.5V AA-size
batteries. It is recommended that ALKALINE batteries be used
for longer battery life and maximum microprocessor performance.
IMPORTANT: New or fully charged batteries are essential to
proper operation of the remote receiver as a latching solenoid
power consumption is substantially higher than standard remote
control systems. Re-chargeable batteries should not be used.
NOTE: The remote receiver will only respond to the transmitter
when the 3-position slide button on the remote receiver is
in the REMOTE position. The remote receiver houses the
microprocessor that responds to commands from the transmitter
to control system operation.
IMPORTANT
24
Requires 4-AA 1.5V
alkaline batteries
Learning
Button
Slide
Switch
ON
REMOTE
OFF
Remote Receiver
Publicidad
