Tennant T981 Manual De Instrucciones página 17

Battery charger settings
! ATTENTION: where machines are shipped without
batteries, the machine is factory set for wet lead-acid
Depending on the type of batteries installed, make
sure the battery charger is properly set.
Failure to observe these instructions could result
in damage to the battery. Depending on the type
of battery selected (wet lead-acid or sealed gel /
AGM), the battery parameters of the machine MUST
directions, see the section "Batteries".
Fitting the squeegee
! ATTENTION: before carrying out the operations
apply the parking brake.
- Loosen the two knobs.
- Locate the two threaded pins in the slots on the
support.
- Connect the suction hose to the squeegee,
bending it to the position as illustrated.
- Tighten the two knobs.
The position of the squeegee is factory-set. Should the
squeegee blade require adjustment, refer to the section
"Squeegee adjustment".
Squeegee adjustment
! ATTENTION: before carrying out the operations
apply the parking brake.
drying. With time, and the constant wiping action, the edge
a new blade is required. The state of wear should be
checked frequently.
To ensure faultless drying, the squeegee must be adjusted
as illustrated, in such a way that the edge of the rear blade
at all points along its length.
EN 17