KRESS KG745 Manual De Instrucciones página 14

3. When transporting your mower in a vehicle,
secure and position it to prevent movement or
damage.
Transporting the battery
1. Ensure the battery is in a safe condition.
2. Use non-conductive packaging when
transporting the battery.
3. The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements.
Transport batteries only when the battery
housing is undamaged. Pack up the batteries in
such a manner that cannot move around in the
packaging.
MAINTENANCE
WARNING! Stop the mower before
removing the grass bag.
NOTE: To ensure long and reliable service, perform
the following maintenance procedures regularly.
Check for obvious defects such as a loose,
dislodged or a damaged blade, loose fittings,
and worn or damaged components. Check that
the covers and guards are all undamaged and
are correctly attached to mower. Carry out any
necessary maintenance or repairs before operating
mower. If the mower should happen to fail despite
EN
regular maintenance, please call our customer
helpline for advice.
BLADE SHARPENING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE.
Sharpening the blade twice during a mowing season
is usually sufficient under normal circumstances.
Sand causes the blade to dull quickly. If your lawn
has sandy soil, more frequent sharpening may be
required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
WHEN SHARPENING THE BLADE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of blade,
removing equal amounts of material from both ends.
NOTE:
1. Be sure the mower is turned off.
2. Place the mower in stand up storage mode.
14
TO SHARPEN BLADE IN A VISE (SEE Fig. J)
A
J
1. Be sure the switch lever is released, the blade
has stopped before removing the blade.
2. Remove blade from mower. See instructions for
removing and attaching blade.
3. Secure blade J-1 in a vise J-2.
4. Wear safety glasses and be careful not to cut
yourself.
5. Carefully file the cutting edges of the blade with a
fine tooth file J-3 or sharpening stone.
6. Check balance of blade. See instructions for
blade balancing.
7. Replace blade on mower and tighten securely.
Refer to instructions below.
BLADE BALANCING (SEE Fig. K)
Check balance of blade by placing center hole in
blade K-1 over a nail or screwdriver shank K-2,
clamped horizontally in a vise K-3. If either end of
the blade rotates downward, file that end. Blade is
properly balanced when neither end drops.
A
K
K-1
K-2
K-3
BLADE MAINTENANCE (See Fig. L1, L2)
Renew your metal blade after 50 hours mowing
or 2 years, whichever is the sooner-regardless of
condition.
Follow these procedures to remove and replace the
blade. You will need garden gloves (not provided)
J-1
J-2
J-3