Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ETV STR61-50-B10
EN
Installation
12. Pull out the planetary gear from the gear housing. Push down the planetary gear fully on the shaft.
Make sure the gear wheel is placed in correct position.
Put the gear back in position. Apply a thin layer of grease on the sealing washer.
13. Put the front part in the clamping jaw and fasten the clamping jaw in the vise.
14. Tighten the front cap nut using adjustable spanners.
© Atlas Copco Industrial Technique AB - 9836 9815 00
7
Publicidad
Tabla de contenido
