Publicidad
Idiomas disponibles
Idiomas disponibles
3. Open the latch (A) and pull out the separator tray
(B).
A
B
4. Remove all contaminations from the separator tray
when you fill abrasive or when it is necessary.
5. Fill the separator with abrasive up to the separator
tray. Fill abrasive when it is necessary.
To fill the product with abrasive 1-15DS
WARNING:
protective equipment during operation. Refer
Personal protective equipment on page 8 .
to
1. Make sure that the abrasive valve is closed. Refer to
To operate the abrasive valve on page 14 .
2. Remove the separator cover.
2070 - 003 - 16.03.2023
Always use personal
3. Open the 2 clamps (A) and pull out the separator
tray (B).
A
B
4. Remove all contaminations from the separator tray
when you fill abrasive or when necessary.
5. Fill the separator with abrasive up to the separator
tray. Fill abrasive when necessary.
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
Do not use the dust
17
Publicidad
