Publicidad
Idiomas disponibles
Idiomas disponibles
C. FILLING BOILER WITH WATER
WARNINGS:
• Carefully read all instructions before removing Boiler Cap.
• Always unplug appliance before filling the Boiler.
IMPORTANT: Use ordinary tap water. Distilled water or demineralized water
is suggested if tap water is too hard. DO NOT add detergents, perfumes,
oils, or other chemical substances to the Boiler. The product warranty will
be null and void if anything other than water is added to the Boiler.
Follow these instructions to fill the Boiler:
• Be sure appliance is unplugged from the
electrical outlet and has cooled for at least
5 minutes before filling with water.
• Make sure Handle Assembly is in the upright
"off" position. Remove Boiler Cap by turning
it counterclockwise.
• Keeping the handle assembly pushed
forward (A), place the filling bottle upside
down and insert the nozzle inside the boiler
opening (B). Press firmly on the bottle to
deactivate the locking mechanism to
release water. The filling bottle allows you
to fill the boiler to correct level, avoiding
overfilling.
• Keep the handle assembly pushed forward
(A) while removing the bottle.
• Replace Boiler Cap by turning it clockwise.
Do not tighten Boiler Cap too much, finger
tightening is sufficient to lock the steam in
the Boiler. If using cold water, heating time is about 3-5 minutes.
If using warm water, heating time is reduced.
IMPORTANT
*
*
• Use the filling bottle when refilling your Boiler. The filling bottle has
a built-in mechanism that prevents overfilling your Boiler. If you use
a measuring cup to refill, add a maximum of 600ml (2 1/2 cups) of
water when the Boiler is empty.
• If re-filling the Boiler while Steam Cleaner has been in use, be sure
to allow it to cool for at least 5 minutes and loosen Boiler Cap slowly
to allow any excess steam to escape before completely removing
Cap. (See page 13, "Refilling Boiler During Use" for detailed
instructions.)
Before Use
11
Publicidad
