Euroflex vapour M4S Manual Del Usuario página 23

10
TROUBLESHOOTING
ISSUES
Steam is not coming out of
the Steam Jets
The Hard Surface Floor Pad
is not adhering to Steamer
The Cleaning Pads are
getting soaked (too wet).
Why?
The steam seems to be
making my floor too wet
IMPORTANT QUESTION:
Q: Do I always need to use a Microfiber Pad when cleaning with
my Floor Steamer?
A. YES! It is critically important to ALWAYS use your Microfiber
Pads. The Floor Steamer should NEVER be used without either a
Hard Surface Floor Pad or Carpet Glider with Carpet Pad.
Q: Why is my Vapour M4S Steam Cleaner sometimes harder to
glide across my floors?
A. If the microfiber floor pad does not have enough moisture,
it can be more difficult to push across your floor. Press the Front
steam button on your handle to emit steam from the underside
of the steamer. This will replenish the moisture in the pad allowing
your steam cleaner to glide easier across the floor while keeping
your pad hot to help loosen and remove dirt & debris while
cleaning. The microfiber pad needs both moisture and heat to
achieve the best cleaning results.
POSSIBLE CAUSES
Improper Handle Assembly
Not enough pressure was
applied when attaching Pad
Floor Pad requires replacing
due to age of the Floor Pad
Boiler is overfilled
Green "Steam Ready Indica-
tor Light" is not illuminated
Front Steam Jets are being
used too frequently
The Cleaning Pad is too wet
(saturated with moisture)
SOLUTIONS
Call Customer Service to receive instructions to correct
the problem
Position Steamer about 2" above Pad and FIRMLY press
it down onto the Pad
Replacement Floor Pads can be purchased at most
electrical appliance retail outlets
Let Steamer run until excess water ceases. Remove
some water from Boiler once the Boiler has cooled
down completely
Wait for green "Steam Ready Indicator Light" to
illuminate
Only use Front Steam Jets in short bursts for cleaning
tougher dirt or to clean hard to reach areas
Replace the wet Pad with a dry, clean Pad and resume
cleaning
Troubleshooting
23