geberit RE 1 Manual De Instrucciones página 24

EN
Replacing the milling cutter
Only use milling cutters with
protection spheres.
Immediately replace milling cutters
without protection spheres.
1
Loosen the retaining screw with an
Allen key.
2
Remove the deburrer head.
3
Loosen the collet and extract the
milling cutter.
4
Insert the new milling cutter and
push it until the stop position is
reached.
5
Tighten the collet.
24
6
Fit the deburrer head on the drive
unit.
7
Tighten the retaining screw with an
Allen key.
9376181515 © 02-2022
964.873.00.0(02)