Publicidad
Idiomas disponibles
Idiomas disponibles
MAKING NUGGET ICE
1.
Make sure that the Drain Tube is firmly plugged and attached
to the Drain Tube Clip before beginning operation.
2.
Lift the Control Panel, and carefully pour water into the
Water Refill Opening to fill the internal water reservoir.
CAUTION: Do not surpass the maximum
water level on the MIN/MAX Markings.
NOTE: Distilled water is best type of
water to fill the water tank with.
3.
After plugging in the ice maker machine, press
the Power Button and it will turn on.
4.
Press the Soft Ice Button to begin making ice. The first
batch of ice will be made within 10 minutes and will
continue until the Ice Bin is full or the internal reservoir requires more water.
NOTE: When the water tank is empty, the ice maker will stop automatically
and the ADD WATER light will turn on. Press the Power Button, fill up
to the water level mark, and press the Soft Ice button again.
NOTE: Nugget ice size will be relatively small for first use. This is a normal part of operation.
5.
The ice maker will stop automatically once the machine is
full and the ICE FULL indicator will turn on.
6.
To remove ice, pull out the Ice Bin, and use the included Ice Scoop to take your desired
amount of ice. Place the Ice Bin back into the machine once you've taken your ice.
NOTE: After use, it is recommended to power off the ice maker and drain the water reservoir.
IMPORTANT: In the event that the power is disconnected during the ice making cycle or that the
LED lights on the Control Panel are blinking, press the Power Button to stop the ice making cycle.
Unplug the unit from the electrical outlet. Wait at least three minutes before restarting the unit.
DRAINING THE ICE BIN
Your NUGGET ICE MAKER's ice storage bin comes with perforated strainer to prevent water
form pooling around your ice. To drain excess water from the Ice Bin, do the following:
•
Remove the Ice Bin from the ice maker using the Handle.
•
Move the Ice Bin to a sink or other drain.
•
Make sure the Ice Bin Drain Plug is safely over sink or drain, then remove the plug.
•
Allow water to drain, then replace the Ice Bin Drain Plug.
DRAINING THE WATER RESERVOIR
When your Ice Maker is not in use, it is recommended to drain the internal water reservoir.
•
Locate a nearby sink, water drain, or container greater than 1.5 quarts.
•
Unhook the Drain Tube from the Drain Tube Clip, then point
the Tube into the sink, drain, or container.
•
Unplug the Drain Tube and allow water to Drain. Then replace
the plug and return the Drain Tube back onto the clip.
7
Publicidad
