Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5. Stand the machine on end and make sure that the
brackets touch the floor.
Storage Switch
The machine has a storage switch (22) that prevents its
startup in the storage position.
It is necessary to remove the safety key and the battery
pack to prevent accidental startup or unapproved use.
The storage switch does not replace this function.
10
TROUBLESHOOTING
Problem
The handle is
not in position.
The machine
does not start.
The machine
cuts grass un-
evenly.
The machine
does not mulch
correctly.
The machine is
hard to push.
There is a high
vibration in the
machine.
Possible cause
Solution
The bolts are not
Adjust the height
engaged correct-
of the handle
ly.
and make sure
that the knobs
and bolts are
aligned correctly.
The battery ca-
Charge the bat-
pacity is low.
tery pack.
The bail switch is
Replace the bail
defective.
switch.
The safety key is
Put in the safety
not put in.
key.
The lawn is
Examine the
rough.
mowing area.
The blade height
Adjust the blade/
is not set cor-
cutting height to
rectly.
a higher position.
Wet grass clip-
Wait until the
pings attach to
grass dries be-
the deck.
fore mowing.
The mulch plug
Install the mulch
is missing.
plug.
The grass is too
Increase the
tall, or the blade
blade/cutting
height is too low.
height.
The grass catch-
Empty the grass
er and the blade
clippings from
drags in thick
the grass catch-
grass.
er.
The blade is un-
Replace the
balanced and
blade.
worn.
English
Problem
The machine
stops during
mowing.
* If you cannot find the solution to these problems, go to
the service center.
11
TECHNICAL DATA
Voltage
Battery model
Charger model
No load speed
Height adjust-
ments
Functions
Weight (without
battery and
charger)
Double-insulated
construction
14
Possible cause
Solution
The motor shaft
1. Stop the mo-
is bent.
tor.
2. Remove the
safety key
and battery
pack.
3. Inspect for
damage.
4. Repair the
machine be-
fore you start
it again.
The blade height
Increase the
is too low.
blade/cutting
height.
The battery pack
Charge the bat-
is out of power.
tery pack.
The grass clip-
Remove the bat-
pings attach to
tery pack and
the deck or the
check the deck.
blade.
Operation tem-
Cool the ma-
perature of the
chine.
machine is too
high.
80 V
BAB703 and other BAB series
GCH8040 and other CAB series
2800 RPM
1 3/8 - 3 3/4" (3.5 - 9.5 cm)
3-in-1 Mulch & Rear Bag & Side
discharge
25.44 kg(56.09 lbs )
Publicidad
