Publicidad
Idiomas disponibles
Idiomas disponibles
MENU 1
Digital filter setting during PCM playback
PCMF>***
Use this to set the digital filter during PCM playback .
Set it as desired .
o By default, the setting is OFF .
o This setting can be made for each input .
OFF
The digital filter is not used during PCM playback .
FIR
The FIR digital filter features a slow roll-off without pre-echo .
RDOT
This digital filter features a slow roll-off that uses a unique analog
interpolation technique with a fluency function .
External clock setting
CLK>***
Use this to set synchronization with an external clock .
o By default, the setting is OFF .
o Set this to OFF when connected to a source device, other than
USB input, that does not support clock synchronization .
OFF
Clock synchronization is not used . The unit will operate with the
clock of the input digital signal .
The built-in oscillator will be used with USB input .
ON
In this mode, the unit is synchronized with the 10MHz clock sig-
nal input through its CLOCK 10MHz IN connector from a clock
generator .
The CLOCK indicator lights . The CLOCK indicator blinks when in
the process of synchronizing or unable to synchronize .
o The clock frequency that can be input is 10 MHz . The input
audio signal and the input clock must be synchronized .
o Be aware that a loud noise could be output from the speakers
during audio playback if the clock signal stops because the
clock generator power switches to standby or the BNC coaxial
cable that is supplying the 10MHz clock signal is disconnected .
Analog output setting
AOUT>***
Use this to select the analog output connector to be used .
o By default, the setting is XLR2 .
ESLA
Analog audio signals are output as ES-LINK Analog (ESL-A)
through the XLR connectors .
o Use connection cables that are shielded and balanced .
o These connections use ordinary XLR cables, but the signals are
transmitted in a unique format, so this setting should only be
used with compatible devices .
o See page 9 for more about ES-LINK Analog (ESL-A) .
XLR2
Analog audio signals are output through the XLR connectors with
pin 2 HOT .
XLR3
Analog audio signals are output through the XLR connectors with
pin 3 HOT .
RCA
Analog audio signals are output through the RCA connectors .
OFF
Analog outputs are disabled and the D/A converter is turned off .
Digital output setting
DOUT>***
Use this to select the digital output connector to be used .
o By default, the setting is OFF .
o The signal is output without upconversion .
o During Super Audio CD playback, this is automatically set to off .
OFF
Digital audio is not output .
XLR
The CD digital audio signal is output from the XLR DIGITAL OUT
connector .
COAX
The CD digital audio signal is output from the RCA DIGITAL OUT
connector .
25
Publicidad
