Publicidad
Idiomas disponibles
Idiomas disponibles
MENU 2
PCM output gain setting
PCMG>***
Use this to set the gain for PCM signal playback . This can be used
to reduce the volume difference between PCM and DSD signal
playback .
Set it as necessary .
o By default, the setting is FULL .
FULL
The gain is not adjusted .
LOW
PCM signal gain is reduced from the original setting before output .
Use when the volume of PCM signals during playback seem loud
compared to DSD signals .
ΔΣ frequency setting during PCM playback
PCMΔΣ>***
The ΔΣ modulator operation frequency during PCM playback can be
set to 128, 256 or 512 .
Select the sound setting you prefer .
o By default, the setting is 512 .
This sets the operation of the ΔΣ modulator as a frequency multiple
of 32, 44 . 1 or 48 kHz .
Example:
When 512 is selected with a 96kHz audio source, the ΔΣ modulator
operates at 24 . 5 76 MHz (48 kHz × 512) .
DSD filter setting
DSDF>***
Use this to set the digital filter during DSD playback .
Set it as desired .
o By default, the setting is OFF .
OFF
No digital filter is used .
F1, F2, F3
A digital filter is used . F1, F2 and F3 are digital filters with different
frequency responses . The cutoff frequency becomes progressively
lower from F1 to F2 to F3 .
Remote control input (RS-232C) connector
setting
RS232C>***
Set this to ON only when using the remote control input (RS-232C)
connector .
o By default, the setting is OFF .
OFF
The remote control input (RS-232C) connector cannot be used .
o The RS-232C transmission and reception circuit is shut down .
ON
The remote control input (RS-232C) connector can be used .
Automatic menu closing time (seconds)
setting
menuTM>***
Setting mode will end if the set amount of time passes without any
setting operation .
o By default, the setting is 10 .
5–30
This can be set in 1-second intervals .
∞
Setting mode will not end automatically .
Press the stop (8) button to end setting mode .
Showing firmware versions
F/W ver.
Press the skip (/) button when "F/W ver . " is shown to check the
versions of other firmware .
I/F ****
I/F firmware
DRV ****
CD/SACD servo and signal processing firmware
M ****
MQA/USB firmware
FPGA ****
FPGA firmware
27
Publicidad
