Publicidad
Idiomas disponibles
Idiomas disponibles
The unit does not respond when buttons are pressed.
e Multiple button presses without pause can cause the main unit
to stop responding . After pressing a button, wait momentarily
for the main unit to respond .
There is noise.
e Place the unit as far away as possible from TVs and other
devices that have strong magnetism .
No sound is output from the speakers. The sound is distorted.
e Check the connections with the amp and the speakers
(page 10) .
e Adjust the volume of the amplifier and other devices .
e If the disc is dirty, wipe it clean (page 8) .
e Super Audio CD digital audio cannot be output from the digital
audio output (DIGITAL OUT) connectors .
e No sound is output when playback is paused . Press the play
(7) button to resume ordinary playback .
e Check the analog output setting (page 25) .
Digital recording is not possible on connected external
equipment.
e You cannot record the digital audio signal as is from a disc that
has such copy-protection .
Noticeable difference in volume between CDs and Super
Audio CDs.
e Volume differences occur when PCM and DSD formats are
converted by D/A converters . Use the amplifier connected to
this unit to adjust the volume . In addition, using MENU 2 to set
PCM output gain (PCMG>) to LOW will reduce PCM volume
and eliminate the volume difference with DSD after D/A con-
version (page 27) .
When connected by optical, no sound or only static is output.
e This unit can only play two-channel audio signals . Check the
signal format of the transmitting device .
Clock sync
The CLOCK indicator does not stop blinking.
e Set CLK> to OFF when not using clock sync .
e A clock signal to which the unit cannot synchronize might be
being input . Check the connections of the clock connectors
and the settings of connected devices . This unit only supports
10MHz clock .
A cyclical noise is being output.
e If a cyclical noise is being output when the unit is in clock sync
mode, the connected device might not also be in clock sync
mode . Check the connection status of the clock connectors
and the clock settings of the connected device .
USB connections with a computer
Computer does not recognize this unit.
e See page 22 for information about supported operating
systems . Operation with unsupported operating systems is not
guaranteed .
There is noise.
e Starting other applications during playback of an audio file
may interrupt playback or cause noise . Do not start other appli-
cations during playback .
e When the unit is connected to a computer via a USB hub, for
example, noise might be heard . If this occurs, connect the unit
directly to the computer .
Audio files cannot be played back.
e Connect the computer with this unit and switch to "USB in"
before starting the audio playback software and audio file play-
back . Audio data might not play back correctly if you connect
this unit with the computer or change its input to USB in after
starting the audio playback software .
Playback stopped working.
e Check the audio output device setting of the operating system .
Try deleting the driver and reinstalling it . For details, see the
ESOTERIC ASIO USB DRIVER Installation Guide included with
the driver .
Since this unit uses a microcontroller, external noise and other
interference can cause it to malfunction. If this occurs, turn the
unit off and wait about one minute before restarting opera-
tion from the beginning.
29
Publicidad
