EdilKamin R Instalación Uso Y Mantenimiento página 29

ELECTRICAL CONNECTIONS
GENERAL WARNINGS
The electrical safety of the system is ensured only when
it is properly connected to an effective grounding system,
implemented according to applicable safety standards: the
gas, water and heating piping are definitely not suitable as
grounding points.
You must check this fundamental safety requirement; if in
doubt, request an accurate electrical check by a professionally
qualified technician, as the manufacturer of the boiler stove is
not responsible for any damage caused by failure to ground the
system.
Get qualified personnel to check that the electrical system is
adequate for the maximum power absorbed by the system, in
particular ensuring that the section of the cables is suitable for
the power absorbed by the loads.
The use of any components that use electricity entails the
observance of some fundamental rules:
• do not touch the appliance with parts of the body which are
wet and/or damp, and/or with bare feet;
• do not pull electrical cables;
• do not allow the appliance to be exposed to the elements
(rain, sun, etc.) unless this is expressly provided for;
• do not allow the appliance to be used by children or non-
experts.
230V electrical power supply connection
Installation of electrical accessory components to the boiler
stove requires electrical connection to a 230 V - 50 Hz
network.
This connection must be professionally carried out as laid
down in local regulations in force at the installation location.
Caution:
The electrical installation must be carried out only by a
qualified technician.
Before carrying out any connections or any operation on
the electrical parts, always disconnect the power supply.
We remind you that it is necessary to install a two-pole
switch on the boiler stove power supply line, with contact
gap greater than 3 mm, which is easily accessible, so as to
make any maintenance operations fast and safe.
Replacement of the power cable must be carried out by
authorised technical personnel.
Failure to comply with the above may compromise the safety
of the device.
INSTRUCTIONS FOR USE
- 29
HYDRAULIC KIT/MOTHERBOARD ELECTRICAL
CONNECTION
The hydraulic kit comes with cabling connected to a connector
(A).
The connector from the hydraulic kit, once mounted, must be
connected to the connector coming from the motherboard (B)
mounted on the product.
The attachments can only be inserted in one direction, therefore
you do NOT need to use unnecessary force.
A
-
B