STOK SGA7000 Manual Del Operador página 10

STEP 12: INSTALL THE NATURAL GAS
BURNERS
See Figure 15.
 Attach electrode assemblies to the natural gas burners
using screws.
 Orient the natural gas burners, which are marked with
"NG", so that the burners with the shortest electrode wires
are on the left and the burners with the longest electrode
wires are on the right.
 Slide burner inlets and electrodes through their respective
holes in the firebox, and then, slide the burners and
electrode wires through the holes in the grill frame.
NOTE: The burners and electrode wires should go through
the same hole in the grill frame.
 Lower the back ends of the burners down onto the tabs
inside the firebox, so the tabs go through the slots in the
burners.
 Install new cotter pins to secure the burners in place.
Fig. 15
ASSEMBLY
STEP 13: INSTALL THE NATURAL GAS
MANIFOLD AND VALVE ASSEMBLY
See Figure 16.
 Place the stem of the natural gas manifold and valve
assembly, marked with yellow screws, into the grill as
shown.
 Insert the tips of the manifold valves into the burners.
Fig. 16
STEP 14: INSTALLING THE NATURAL GAS
HOSE
See Figure 17.
 Reconnect the electrode wires and reassemble the control
panel, bezel and knobs by reversing the instructions in
STEPS FIVE through EIGHT.
 Remove the rubber cap from the stem of the natural gas
manifold and valve assembly.
 Using a wrench (not provided), screw the collar of the
natural gas hose to the natural gas manifold and valve
assembly located behind the control panel. Tighten
securely.
Fig. 17
10
BURNER
MANIFOLD
TIP
MANIFOLD
STEM
NATURAL GAS MANIFOLD
AND VALVE ASSEMBLY
NATURAL GAS
MANIFOLD AND VALVE
ASSEMBLY
NATURAL GAS
VALVES
HOSE