STOK SGA7000 Manual Del Operador página 8

STEP 5: REMOVE THE CONTROL KNOBS
See Figure 7.
 Locate the set screw inside the hole in the control knob.
NOTE: The rubber on the knob may need to be rotated
to gain access to the set screw.
 Insert the 2 mm hex key into the hole and rotate the set
screw counter-clockwise until the control knob is loose
enough to remove.
 Repeat steps to remove remaining control knobs.
Fig. 7
STEP 6: REMOVE THE CONTROL KNOB BEZEL
See Figure 8.
 Loosen the two black screws securing the control knob
bezel.
 Remove the control knob bezel.
 Repeat steps to remove remaining control knob bezels.
CONTROL
KNOB BEZEL
BLACK
SCREW
PHILLIPS
SCREW
DRIVER
Fig. 8
ASSEMBLY
STEP 7: REMOVE THE CONTROL PANEL
See Figures 9 and 10.
 Loosen and remove the six screws and nuts securing the
control panel.
NOTE: Some models may not include nuts. For these
models, remove the screws from the threaded holes.
 Carefully remove the control panel from the grill.
NOTE: Jerking the control panel away from the grill can
damage the wires behind the panel.
SCREWS
CONTROL
KNOB
2 mm
HEX KEY
Fig. 9
STEP 8: DISCONNECT THE ELECTRODE WIRES
FROM THE IGNITOR
See Figure 10.
 Locate the wires going from the ignitor on the control
panel to the electrodes inside the firebox.
 Carefully disconnect the wires from the ignitor.
Fig. 10
8
IGNITOR
ELECTRODE
WIRE
CONTROL
PANEL