Flo 79502 Manual De Instrucciones página 24

EN
is specifi ed in the technical data table. Pay particular attention that the operator's hands and feet are not in close proximity to
the cutting parts of the tool. If lignifi ed hedge twigs get stuck in the cutting area of the shears, immediately turn off the shears by
removing the fi nger from the power switch then remove the safety key from the socket and carefully, taking care not to get hurt,
remove the stuck twig from the shears cutting part.
Procedure in the case of jamming the cutting element
In the event of a sudden stop of the cutting element during operation, for example, as a result of an attempt to cut a too thick
element, release the pressure on the power switch and make sure that it is in the off position. Remove the safety key from the
tool socket. If the cause of the jam can be eliminated easily and quickly, it is not necessary to disassemble the cutting element,
but it is recommended. However, if the cause of the jam cannot be eliminated easily and quickly, remove the cutting element and
proceed to remove the cause of the jam.
If the user has doubts as to how to remove the cause of the jamming of the cutting element, always disassemble it fi rst.
After removing the cause of jamming, check whether the cutting element has not been damaged or deformed. If any are found,
replace the cutting element with a new one that is free of defects. Do not repair the cutting element yourself, for example, straight-
en the blades. Working with a damaged or improperly repaired cutting element can lead to injury or damage to the machine.
Additional notes
Take regular breaks during work.
Do not overload the tool. The temperature of the external surface must never exceed 60°C. After fi nishing work, turn off the shears,
disconnect the battery and perform maintenance and inspection.
Storage
Store the product in a closed and shaded place in a room with ventilation. The place of storage should be out of the reach of
children. Charge the battery and disconnect the cutting element before long-term storage (several months and longer). Clean
and coat the cutting element with a thin layer of general purpose lubricating oil to prevent rust. Secure the blades with the guards
provided with the tool. In case of a very long storage period, it is recommended to charge the battery every six months.
Before each start of work, inspect the tool for wear and damage. Only work with an operational and fully equipped tool.
Spare parts
For a detailed list of spare parts for the product go to the "Download" section in the product tab at the TOYA SA websites: www.
toya.pl and www.toya24.pl.
O R I G I N A L I N S T R U C T I O N S
24