Descargar Imprimir esta página

GreenWorks G20 Manual Del Operador página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
EN
PROBLEM
The motor buz-
zes, but you can
not start the ma-
chine.
There is no wa-
ter.
8
TECHNICAL DATA
Model No.
Rated Voltage
Rated Pressure
Permissible Pressure
Power Rating
Rated Water Flow
POSSIBLE
SOLUTION
CAUSE
The supply volt-
Make sure that
age is low.
only the pres-
sure washer op-
erates on the cir-
cuit.
The system has
1. Stop the ma-
remaining pres-
chine.
sure.
2. Pull the gun
trigger on
spray wand
to release
pressure
3. Start the ma-
chine.
The voltage de-
Disconnect the
creases across
extension cord,
extension cord.
and connect the
machine directly
into the outlet.
You do not use
Speak to a per-
the machine for
son of an ap-
a long time.
proved service
center.
There is remain-
1. Disconnect
ing friction in
the water
components.
supply.
You can hear a
2. Turn the ma-
hum.
chine on for
2 or 3 sec-
onds.
3. Repeat the
above step
for several
times.
The water supply
Turn the water
is off.
supply on.
The garden hose
Make sure that
is blocked.
the garden hose
is free from
blockage.
G20
220-240 V, 50 Hz
8 MPa
11 MPa
1400 W
5.6 l/min
English
Maximum Water Flow
Maximum Water Inlet Pres-
sure
Maximum Water Inlet Tem-
perature
Measured sound pressure
level
Measured sound power lev-
el
Guaranteed sound power
level
Vibration
Protection Degree
9
WARRANTY
(The full warranty terms and conditions can be found on
Greenworks website https://www.greenworkstools.eu)
The Greenworks warranty is 3 years on the product,
and 2 years on batteries (consumer/private usage)
from the date of purchase. This warranty covers
manufacturing faults. A faulty product under warranty
might be either repaired or replaced. A unit that has
been misused or used in other ways then described
in the owner's manual might be rejected for warranty.
Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not
affected by any additional warranty offered by a dealer
or retailer.
A faulty product must be returned to the point of
purchase in order to claim for warranty, together with
the proof of purchase (receipt).
10
EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name:
GLOBGRO AB
Globe Group Europe
Address:
Riggaregatan 53, 211 13 Malmö, Sweden
Name and address of the person authorised to compile
the technical file:
Name:
Micael Johansson
Address:
Riggaregatan 53, 211 13 Malmö, Sweden
Herewith we declare that the product
8
7.6 l/min
0.7 MPa
40 °C
L
= 80 dB(A), K
= 3
pA
pA
dB(A)
L
= 87.6 dB(A)
wA
L
= 91 dB(A)
wA.d
2
2
< 2.5 m/s
, K = 1.5 m/s
IPX 5
Double-insulated con-
struction.

Publicidad

loading