Publicidad
Idiomas disponibles
Idiomas disponibles
3. Headlight installation
3.1 Loosen the headlight screw from the front fork; install the headlight in the
front fork screw hole, and tighten the screw with an Allen tool.
4.Front wheel installation：
4.1 Cut the wrapping rope, remove the front wheel, remove the front fork
protection lever and the front wheel protection cover.
4.2 Make sure that the front wheel is in line with the rear wheel, then start
installation. First pull the wheel upwards, put the disc brake pad into the front
brake caliper, and then use 15 wrench to tighter the front hub fixing screw.
4.3 Adjust the adjusting screw of the disc brake to make the disc brake rotor
without obvious friction
5.Pedal installation：
Check two pedals. The one imprinted "L" should be installed on the left
(without chain ring), and another one imprinted " R" should be installed on the
right (with chain ring), rotate clockwise, and then use a 15 wrench tighten the
pedal spindle.
6
Publicidad
