Publicidad
Idiomas disponibles
Idiomas disponibles
3. Headlight installation
3.1 Loosen the headlight screw from the front fork; install the headlight in the
front fork screw hole, and tighten the screw with an Allen tool.
4.Front wheel installation：
4.1 Cut the wrapping rope, remove the front wheel, remove the front fork
protection lever and the front wheel protection cover.
4.2 Make sure that the front wheel is in line with the rear wheel, then start
installation. First install the front wheel installation quick release on the front
wheel hubs,(Note: The quick release handle is on the side of the wheel, and
both sides of the mandrel have conical spring heads inward.) Then pull the
wheel upwards, put the disc brake pad into the front brake caliper, and then
use hand to tighten the screw nut, and firmly lock the front hub with the quick
release handle backwards.
4.3 Adjust the adjusting screw of the disc brake to make the disc brake rotor
without obvious friction
5.Pedal installation：
Check two pedals. The one imprinted "L" should be installed on the left
(without chain ring), and another one imprinted " R" should be installed on the
6
Publicidad
