Publicidad
Idiomas disponibles
Idiomas disponibles
6.Charging
1. When charging the e-bike battery, simply place the bike within reach of the
power supply, connect the charge's plug to the charging base on the battery,
and then plug in the charger's power plug to charge.
2. The battery can be installed on the bike for charging, or can be removed
and placed in a convenient place for charging.
3. The red light indicates it is in charging, green light indicates the battery is
fully charged (please put off the plug from the wall). The charging time
depends on the battery capacity, the general charging time is 4-6 hours.
4. Warning: It is forbidden to charge for more than 10 hours, please keep
away from high temperature environment and store in a shade.
7 . Installation Instruction
1. Open the carton, take our the e-bike, and cut the wrapping rope with tools.
2. Handlebar installation:
2.1 First loosen the gland screw directly above the standpipe with M5 Allen wrench,
then use M4 Allen wrench to loosen the lock screw on the standpipe, and then turn
the standpipe upside down which is turn clockwise to the front of the bike, use an M5
Allen wrench to tighten the gland screw directly above the standpipe until the fork
does not loosen, when it can rotated smoothly, then tighten the two locking screws of
the standpipe with an M4 Allen key.
2.2 Use the M4 Allen wrench to remove the front cover of the standpipe， Place
the middle of the handlebar on the handlebar installation position of the
standpipe，make it be 90 degrees with the frame, and then put on the gland
screw, use M4 hexagon wrench to tighten the cover mounting screws of the
standpipe.(Notes: You should use the same power to tighten the 4 gland
screws.)
2.3 Adjust the correct position of the handlebar, and then use tools to lock the
handlebar cover.
5
Publicidad
