Introduction For Buttons On Remote Controller - INVENTOR COOL FCOOL-8BS Manual De Usuario

Introduction for buttons on remote controller

4
FAN button
By pressing the FAN button the fan speed is selected in a circular motion as follows: AUTO,
SPEED 1 ( ), SPEED 2 (
SPEED 1 (equals to low fan speed)
SPEED 3 (equals to high fan speed)
Note:
Under AUTO speed, the air conditioner will select the proper fan speed automatically according to
■
the room's temperature.
Fan speed can not be set under DRY mode.
■
5
SWING button (not applicable for this model)
By pressing the SWING button the air outlet directional louver is activated.
Note this may not apply on all units.
6
SLEEP button
Under COOL only you may press this button as to activate the SLEEP function. This function is not
applicable under HEAT, DRY, FAN and AUTO mode.
The SLEEP function initially and after one hour of operation the temperature raises by one degree.
After the operation of an additional two hours ( a total of three hours) the temperature raises by
another 2 degrees. This function is not applicable in FAN or DRY mode. The raise in temperature
is not indicated on the digital control display. This function is activated and deactivated by the user,
it does not occur automatically.
7
TIMER button
When the unit is ON, press the TIMER button to set TIMER OFF. T-OFF and H icon will appear
■
flashing. Within 5 sec press the + or - button once to adjust the Timer OFF. By pressing the + or -
buttons this will increase and decrease the values by 0,5h. By continuously pressing the + or - buttons
for 2s, the time will change rapidly. Release the button after your required set time is reached, followed
by pressing the TIMER button to confirm. T-OFF and H icons will stop flashing.
When the Unit is OFF, press the TIMER button to set the Timer ON. t-on AND h ICON will be flashing.
■
Within 5 sec, press + or - buttons to adjust the time for Timer ON. By pressing the + or - button this will
increase or decrease the values by 0.5h.By continuously pressing the + or - buttons for 2s, the time
will change rapidly. Release the button after your required set time is reached, followed by pressing the
TIMER button to confirm. T-ON and H icons will stop flashing.
Cancel Timer ON/OFF. If the TIMER function is set, press the TIMER button once to review the
■
remaining time frame. Within 5 sec, press TIMER button once again in order to cancel this function.
), SPEED 3 (
AUTO
).
SPEED 2(equals to medium fan speed)
8