Publicidad
Idiomas disponibles
Idiomas disponibles
*The above data could be change without notice in order to improve the
performances.
STANDARD TEST CONDITIONS –EN 14511‐
OPERATING CONDITIONS IN COOLING AND DEHUMIDIFICATION MODE:
‐Inside 27℃ DB, 19℃ WB
‐Outside 35℃ DB, 24℃ WB
OPERATING CONDITIONS IN HEATING MODE:
‐Inside 20℃ DB
‐Outside 7℃ DB, 6℃ WB
INSTALLATION
2
2.1 POSITIONING THE AIR CONDITIONER(P3)
To maintain the best performance from your air conditioner, prevent breakdowns or hazards, you
must position it correctly. Please follow the guidelines and instruction below in full, as failure to do
so could cause potential installation problems.
‐The air conditioner must be installed on an
exterior wall that has access to the outside
with a minimum of a meters clearance to
the outside.
‐The air conditioner must be fitted leaving
room all around as illustrated in the paper
template.
‐The wall on which the air conditioner is
installed must be sturdy and able to
withstand the weight of the air conditioner.
After determining the best place for installation as described above, please check to ensure that
the wall can be drilled in the chosen area without interfering with other structures or installation
(beams, piers, pipes, wires, etc.).
Please also ensure that there are no obstacles on the outside of the wall, which may obstruct air
circulation through the drilled holes, for example: plants and their leaves, slats or paneling, drain
pipes, overflows and gratings, etc. Any obstruction could interfere with the correct performance of
the conditioner.
2.2 PAPER TEMPLATE (P4)
Fasten the template to the wall once the following
guidelines have been thoroughly checked.
‐Do not drill any holes until you are completely
confident that there are no obstacles in the area
you wish to drill and there are no obstructions,
which could be hidden by the construction of the
wall, for example: Electrical wiring, water & gas
pipes or supporting lintels or beams.
‐Ensure that a spirit level is used, as the air
conditioner must be level.
‐Follow the installation instruction in full.
EN
P3
P4
6
Publicidad
