Publicidad
Idiomas disponibles
Idiomas disponibles
2.6 FITTLING THE AIR CONDITIONER ON BRACKET(P13，P14)
After checking again that the fastening
bracket is securely fastened to the wall, and
that any necessary preparations for electric
connection and condensate drainage (if it
needs) have been made, fasten the air
conditioner to its supporting bracket.
Lift it up by holding the sides at the bottom.
Tilt the air conditioner slightly toward you to
facilitate the operation of fastening it to the
bracket. The air conditioner can now be
pushed firmly against the wall. Inspect
carefully the installation to make sure that
the insulating back panel must fit firmly
against the wall and there are no fissures at
the back of the air conditioner.
The appliance shall not be installed the laundry.
The appliance must be positioned so that the plug is accessible.
The appliance shall be installed in accordance with national wiring regulations.
2.7 FITTLING THE GRATINGS(P15)
To fit the external two gratings, please proceed as following:
‐Put the silicon glue around the ring, and fix
the two gratings from outside.
‐Pay attention the flap direction, always
keep the shaft side with upper direction.
‐With system "A" water drainage solution,
open a round hole with the flap, and try to
fix the drainage pipe inside the plastic clip.
‐Try to open and close the flap, should be no
any interference with the drainage pipe.
‐For gratings surface, we could paint them
like the wall if necessary.
P14
EN
P13
P15
10
Publicidad
