Publicidad
Idiomas disponibles
Idiomas disponibles
(accessory) is essential. Danger of glass breaking.
On profiled surfaces, varnish can be removed using an appropriately fitting
spatula and brushed off with a soft wire brush.
Shaping Plastic Tubing (see figure C)
Mount the reflector nozzle (accessory). To avoid
kinking of the tubing, fill the tubing with sand and
plug both ends. Heat the tubing evenly by by
applying the heat from side to side.
Welding Plastics (see figure D)
Mount the reduction nozzle and the welding shoe
(both accessories). The workpieces to be welded
and the welding rod (accessory) must be of the
same material (e.g. both of PVC). The seam
must be clean and grease-free.
Carefully heat up the seam location until it
becomes doughy. Please note that the
temperature difference between the doughy and
liquid state of plastic is low.
Feed in the welding rod and allow it to run into
the gap so that a uniform bead is produced.
Shrinking (see figure E)
Mount the reduction nozzle (accessory). Select
the diameter of the heat-s hrinkable sleeve
(accessory) according to the workpiece (e.g. a
cable lug). Heat the heat-shrinkable sleeve evenly.
Defrosting Water Pipes (see figure F)
Before heating pipes, check to make sure
that it is actually a water pipe. Water lines
often do not differ in appearance from gas lines.
Gas lines are not to be heated under any
circumstances.
Place on the angle nozzle (accessory). Heat the
frozen zone always from the outside to the middle.
Heat up plastic pipes as well as connections between pipe pieces especially
careful to prevent damage.
Soft Soldering (see figure G)
For point soldering, place on the reduction nozzle,
for the soldering of pipes/tubing, place on the
reflector nozzle (both accessories).
If solder without flux is used, apply soldering
grease or paste to the location to be soldered.
Warm the location to be soldered for 50–120
Publicidad
