Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: To prevent cross contamination/infection, the Smartpump 2.0 tubing
and breastmilk expression set should never be shared between mothers or re-
sold from one mother to another. Each user should use her own Smartpump 2.0
tubing and breastmilk expression set.
3. CLEANING INSTRUCTIONS
Unless otherwise instructed by your healthcare provider,
follow these sanitizing and cleaning instructions.
WARNING: To prevent cross contamination/infection,
the Smartpump 2.0 tubing and breastmilk expression
set should never be shared between mothers or re-sold
from one mother to another. Each user should use her
own Smartpump 2.0.
3.1 Cleaning of Breastmilk Expression Set Before First Use
1. Always wash and dry hands thoroughly with soap and water before handling
the breastmilk expression set.
2. Disassemble the breastmilk expression set and place parts in a large pot.
3. Cover the parts in water making sure there is room for all of the parts to float freely
in the pot.
4. Bring the water to a boil and allow the parts to boil for 5 minutes.
5. After boiling remove the parts from the pot with tongs and place on a clean
towel to dry, covering the parts with a second towel.
6. Allow the parts to dry completely before assembly and use. Partially dried
parts may affect the operation of the pump.
7. Once parts are dry they can be stored in a clean plastic bin with a lid or in a
clean plastic zipper bag.
3.2 Cleaning of Breastmilk Expression Set After Each Use
Disassemble the breastmilk expression set, setting aside the tubing and
1.
connectors.
2. Rinse all parts with cold water immediately after each use. Place pump parts
in a clean wash basin used only for washing infant feeding equipment. Do not
place pump parts directly in the sink, because germs in sinks or drains could
contaminate the pump.
3. Hand wash all parts of the breastmilk expression set using warm soapy water.
A nipple brush may be used to scrub the hard plastic pieces of the breastmilk
expression set, but should not be used on the soft silicone valve or diaphragm.
4. Rinse parts with running clean, warm water, or by submerging in fresh water
in a separate basin that is used only for cleaning infant feeding items.
5. Place pump parts on a clean, unused dish towel or paper towel in an area
protected from dirt and dust. Do not use a dish towel to rub or pat items dry.
Allow the parts to dry completely before assembly and use. Partially dried
parts may affect the operation of the pump.
6. Once parts are dry they can be stored in a clean plastic bin with a lid or in a
clean plastic zipper bag.
10
Do not boil or
wash tubing or
connectors!
When sanitizing
parts, use enough
water to keep
parts afloat!
Publicidad
