BEMIS HD-7500 Manual Del Usuario página 8

5. Connect the Water Hoses
1. Install the t-valve onto the toilet tank. Ensure the rubber
gasket is properly seated inside the t-valve.
2. Connect your existing toilet hose to the water shut-off valve and t-valve.
3. Connect the provided bidet hose to the bidet seat and t-valve.
4. Open the water shut-off valve. Check for any leaking or dripping.
Use a wrench to tighten any loose connections.
*Shut-off valves may vary. If supplied parts do not fit, please call
847.458.2334. Alternate fittings are available upon request.
6. Plug It In!
Plug the power cord into a 120V power outlet. The HD-7500 will beep.
Press "Rear Wash" while unseated. The water will start filling the tank
and the bidet will beep 3 times. Once the tank is full, the beeping will stop.
7. Mounting the Remote
Adhesive Tape Wall
1. Remove the adhesive cover from the back of bracket and
place the bracket where desired.
2. Insert the supplied batteries (AAA) and close the battery cover.
Ensure the batteries are inserted properly accordingly to polarity.
14
Toilet Tank
Rubber Washer
*Inside T-valve
T-Valve
Toilet Hose
Bidet Hose
Shut-off Valve
15